Icopal’s TPO Contact Adhesive is an instant grabbing high-performance contact adhesive that has been formulated for bonding non-fleecebacked TPO / FPO single-ply roofing membranes to various substrates, such as wood, masonry and other approved substrates in both horizontal and vertical applications.
The product is brown in appearance and is packaged in a 20 litre container size and is applied using a roller directly from the container.
Features & Benefits
- Roller applied for simple application
- Strong, permanent, polymeric bond
- Excellent resistance to aging
- Cold applied
- Substantial coverage rate
- High heat resistance
||Icopal TPO Contact Adhesive 20L
Product Data and Performance
||5 to 25 °C
|Effective Area per Container (1) :
||25 - 30 m²
|Application Rate (1)(2) :
||0.3 to 0.4 L·m-²
|Open Time (3) :
||5 - 50 minutes
||Within 24 hours
(1) Consumption rates are typical. Porous surfaces and substrates may require more bonding adhesive than the typical.
(2) Per mating side.
(3) Dependent on the prevailing conditions such as temperature and humidity.
Icopal TPO Contact Adhesive is compatible with tissue faced PIR insulations boards along with a variety of substrates commonly encountered in flat roofing applications such as timber, concrete, metal and more.
Important Note: The adhesive is not compatible with expanded polystyrene (EPS) or extruded polystyrene (XPS) insulation boards, due to the solvent content.
Icopal TPO Contact Adhesive is suitable for bonding both on the flat and for vertical applications due to its instant grab, making it the ideal choice for detail work.
Icopal’s TPO Contact Adhesive provides an outstanding bond and has been formulated to provide a simple application for the application of roof detailing sheets. It exhibits high adhesive and cohesive bond strength and provides excellent flexibility making it an ideal adhesive for TPO/FPO roofing membranes.
There is no need to invest in equipment to secure the roof membrane. The Icopal TPO Contact Adhesive is simply applied by brush or roller providing a quick and easy application.
The low viscosity of the formulation creates the perfect consistency for application and provides exceptional coverage rates, and as a result reduces contractor task time when installing the membrane.
The surface, on or against which the adhesive is to be applied, shall be clean, smooth, dry, free of fins, sharp edges, loose and foreign materials, oil and grease. Depressions greater than 6 mm should be filled and all sharp projections shall be removed. Ensure the substrate is dry – Please refer to the ‘Properties’ section regarding application temperatures. Ambient and substrate temperatures must be at minimum 5 °C. Do not apply if rain is imminent. Do not apply if there is any standing water or frost, or condensation.
Remove the lid and thoroughly stir before (for a minimum
5 minutes) and during application. Apply an even film of Icopal TPO Contact Adhesive to both substrate and membrane using a medium nap roller. Application shall be continuous and uniform avoiding globs or puddles. Do not apply adhesive to areas to be hot air weld jointed. It is recommended to mark out these areas prior to application of the adhesive.
An open time of 1 to 30 minutes (dependent on atmospheric conditions) is recommended before assembly. Icopal TPO Contact Adhesive must be allowed to dry until it does not string or stick to a dry gloved finger touch. If the adhesive is shown to be sticky or stringy then it requires longer to dry.
The coated surfaces must be kept clean before bonding. Any coated area which has been exposed to rain should be allowed to dry and then recoated.
Once the adhesive is ready for mating, carefully roll the membrane onto the adhesive coated substrate while avoiding wrinkles. Immediately brush down the bonded portion of the sheet with a soft bristle broom or a clean dry weighted roller applicator to achieve maximum contact, without air pockets or wrinkles.